Proportioners
Spray Guns
Spray Hoses
Transfer Pumps
Safety & Protection
Gensets & 
0.5lb Open-cell Spray Foam
2.0lb Closed-cell Spray Foam
3.0lb Roofing Foam
Silicone Coatings
Sealants
1.0lb Kits
2.0lb Kits
3.0lb Kits
closeGraco Heated Hose
)
view largerState-of-the-art design gives the Graco hoses superior performance in the plural-hose market
Graco's Heated Hoses are a vital component of a spray foam insulation system. These hoses are the most advanced in our industry and when paired with a Graco Reactor Proportioner provide an unparalleled level of performance.- Rapid heating due to the copper-wound technology
- Low permeability to avoid crystallization and/or other chemical reactions of the materials in the lines
- Different fittings on the A and B sides to prevent incorrect corrections
- Low-voltage to reduce the risk of injury
Components and details of a Graco Heated Hose System
- Fluid Temperature Sensor (FTS)
- Fluid Temperature Sensing cable
- Hose assembly cable
- Heated hose wire
- Air line
- Fluid hoses
- Ground wire
There are many different ways you can setup your heated hose system. CPi has picked a few of the most common methods and outlined them below.
2000/3500 psi 150 ft. Hose System (normal flow)
- Two 50ft lengths of 3/8" Heated Hose with Thermocouple Wire
- Fluid Temperature Sensor
- 50ft length of 3/8" Heated Hose
- 10ft length of Whip
- 50ft length of Scuff Jacket
2000/3500 psi 300ft Hose System (high flow)
- Two 50ft lengths of 1/2" Heated Hose with Thermocouple Wire
- Three 50ft lengths of 3/8" Heated Hose with Thermocouple Wire
- Fluid Temperature Sensor
- 50ft length of 3/8" Heated Hose
- 10ft length of Whip
- 50ft length of Scuff Jacket
