Proportioners
Spray Guns
Spray Hoses
Transfer Pumps
Safety & Protection
Gensets & 
0.5lb Open-cell Spray Foam
2.0lb Closed-cell Spray Foam
3.0lb Roofing Foam
Silicone Coatings
Sealants
1.0lb Kits
2.0lb Kits
3.0lb Kits
close
)
view largerThese foam kits have long been favored by foam and conventional roofers to repair smaller problem areas on roofs. Clear instructions allow even novices to produce excellent results within a few minutes. Especially on roof applications, sprayers will appreciate the high output and smooth round and fan spray patterns which can be produced with the included disposable gun.
3.0 lb Spray Foam Kits
High-density, disposbale Spray Foam Kits for repair, patching and filling work
Touch 'N Seal Spray Foam Kits are designed for use in commercial sealing, insulating, patching and filling applications. Portable and disposable, these two-component foam systems provide a quick, consistent flow of polyurethane foam that dries in less that one minute.- Portable, disposable, self-contained units
- High closed cell content of cured foam makes it suitable as as a general sealant to prevent air leakage in cold storage and other insulating applications
- Foam expands 30 times and dries in less than 1 minute
- Rip 'n Go set-up provides easy access to new, comfort-grip handle (single carton units)
- No CFCs or urea formaldehyde
- Clear, color-coded hoses
- Available in a 120 board feet kit
Spray Foam Kit 200 & 600 both included the following:
- Two cyclinders (Components A & B)
- P2 anti-crossover gun with 10' hoses
- Extra Nozzles (5 of each)
- Latex Gloves
- Assembly Wrench
- O-ring
- Petroleum Jelly
Technical Data
- Density (ASTM D-1622): 3.0 pcf
- K-Factor (ASTM C-518): 0.17 BTU • in • hr -1 • ft -1 • F -1
- R-Value (ASTM C-518): 5.9 per inch
- Compressive Strength (ASTM D-1621): 40 psi
- Water Absorption (ASTM D-2842): 0.5-1.0% vol
- Closed Cell Content (ASTM D-2856): 90% minimum
- Maximum Service Temperature for Cured Foam: 240°F (116°c)
- Shelf Life: 18 months
- Use all contents within 30 days of intial dispensing
These 3 lb. spray foam kits should be used wherever thermal insulation with high compressive strength is required. Compared with the 2 lb. kit, the 3 lb. kits offer more than twice the compressive strength, of about 40 psi. This makes it suitable for roofing applications where occasional foot traffic by maintenance crews is expected. Obviously, the intended applications are repairs and patches of less than a thousand square feet.
Foam kits are ideal for small jobs because they are portable, self-contained and a cost effective method to get the job done quickly.
Foam kits are a useful tool to seal roof and wall junctions as well as wall to ceiling and wall to floor junctions.
Foam kits can be used to insulate and reduce road noise in the vehicle manufacturing.
Because foam kits are portable and require no outside power source, they are ideal for general maintenance and HVAC applications.
Even fairly new duct work often is quite leaky. Contractors and home owners alike can reseal ducts and often reduce the air and energy loss from 30% to 50% to nothing.
Applicators love these kits because they require no power or compressed air. This is a real advantage when a repair is made on a large roof.
Insulation Contractors-Small jobs/touch-ups
Cold Storage Construction
RV & Bus Industry
Plant Maintenance and Repair
Duct Work Sealing
